Edge-Core ECS4660-28F Management Manual page 1592

Hide thumbs Also See for ECS4660-28F:

Table of Contents

| CFM Commands

Link Trace Operations

ethernet cfm

Global Configuration

Before setting the cache size, the cache must first be enabled with the

ethernet cfm linktrace cache

If the cache reaches the maximum number of specified entries, or the

size is set to a value less than the current number of stored entries, no

new entries are added. To add additional entries, the cache size must

first be increased with this command, or purged with the

cfm linktrace-cache

This example limits the maximum size of the link trace cache to 500

Console(config)#ethernet cfm linktrace cache size 500

Console(config)#

This command sends CFM link trace messages to the MAC address of a

ethernet cfm linktrace {dest-mep destination-mpid | src-mep

source-mpid {dest-mep destination-mpid | mac-address} |

mac-address} md domain-name ma ma-name [ttl number]

destination-mpid – The identifier of a remote MEP that is the target

of the link trace message. (Range: 1-8191)

source-mpid – The identifier of a source MEP that will send the link

trace message. (Range: 1-8191)

mac-address – MAC address of a remote MEP that is the target of

the link trace message. This address can be entered in either of the

following formats: xx-xx-xx-xx-xx-xx or xxxxxxxxxxxx

domain-name – Domain name. (Range: 1-43 alphanumeric

ma-name – Maintenance association name. (Range: 1-44

alphanumeric characters)

number – The time to live of the linktrace message. (Range: 0-255

clear ethernet

Chapters

Table of Contents