Edge-Core ECS4660-28F Management Manual page 1103

E
XAMPLE
Console(config)#interface ethernet 1/1
Console(config-if)#network-access link-detection link-up action trap
Console(config-if)#
Use this command to detect link-up and link-down events. When either
network-access
event is detected, the switch can shut down the port, send an SNMP trap,
link-detection
or both. Use the no form of this command to disable this feature.
link-up-down
S
YNTAX
D
EFAULT
Disabled
C
OMMAND
Interface Configuration
E
XAMPLE
Console(config)#interface ethernet 1/1
Console(config-if)#network-access link-detection link-up-down action trap
Console(config-if)#
Use this command to set the maximum number of MAC addresses that can
network-access
be authenticated on a port interface via all forms of authentication. Use the
max-mac-count
no form of this command to restore the default.
S
YNTAX
D
EFAULT
1024
network-access link-detection link-up-down
action [shutdown | trap | trap-and-shutdown]
no network-access link-detection
action - Response to take when port security is violated.
shutdown - Disable port only.
trap - Issue SNMP trap message only.
trap-and-shutdown - Issue SNMP trap message and disable
the port.
S
ETTING
M
ODE
network-access max-mac-count count
no network-access max-mac-count
count - The maximum number of authenticated IEEE 802.1X and
MAC addresses allowed. (Range: 0-1024; 0 for unlimited)
S
ETTING
– 1103 –
| General Security Measures
C 29
HAPTER
Network Access (MAC Address Authentication)