Edge-Core ECS4660-28F Management Manual page 1309

Hide thumbs Also See for ECS4660-28F:

Table of Contents

Once the ring has been activated with the

configuration of the control VLAN cannot be modified. Use the

command to stop the ERPS ring before making any

configuration changes to the control VLAN.

Console(config)#vlan database

Console(config-vlan)#vlan 2 name rdc media ethernet state active

Console(config-vlan)#exit

Console(config)#interface ethernet 1/12

Console(config-if)#switchport allowed vlan add 2 tagged

Console(config-if)#interface ethernet 1/11

Console(config-if)#switchport allowed vlan add 2 tagged

Console(config-if)#exit

Console(config)#erps domain rd1

Console(config-erps)#control-vlan 2

Console(config-erps)#

This command activates the current ERPS ring. Use the no form to disable

the current ring.

ERPS Configuration

Before enabling a ring, the global ERPS function should be enabled with

command, the east and west ring ports configured on each

node with the

command, and the control VLAN configured with the

Once enabled, the RPL owner node and non-owner node state machines

will start, and the ring will enter idle state if no signal failures are

Console(config-erps)#enable

Console(config-erps)#

command, the RPL owner specified with the

| ERPS Commands

command, the

control-vlan

Chapters

Table of Contents