Edge-Core ECS4660-28F Management Manual page 1951

PIM6 Shared Mode Commands
router pim6
ipv6 pim
Table 288: PIM-DM and PIM-SM Multicast Routing Commands (Continued)
Command Function
show ipv6 pim bsr-router Displays information about the BSR
show ipv6 pim Displays active RPs and associated multicast routing
rp mapping entries
show ipv6 pim rp-hash Displays the RP used for the specified multicast group
This command enables IPv6 Protocol-Independent Multicast routing
globally on the router. Use the no form to disable PIM multicast routing.
S
YNTAX
[no] router pim6
D S
EFAULT ETTING
Disabled
C M
OMMAND ODE
Global Configuration
C U
OMMAND SAGE
This command enables PIM-DM and PIM-SM for IPv6 globally for the
◆
router. You also need to enable PIM-DM and PIM-SM for each interface
that will support multicast routing using the
make any changes necessary to the multicast protocol parameters.
To use PIMv6, IPv6 multicast routing must be enabled on the switch
◆
using the ipv6 multicast-routing
To use IPv6 multicast routing, MLD proxy cannot be enabled on any
◆
interface of the device (see the
E
XAMPLE
Console(config)#router pim6
Console(config)#
This command enables IPv6 PIM-DM or PIM-SM on the specified interface.
Use the no form to disable IPv6 PIM-DM or PIM-SM on this interface.
S
YNTAX
[no] ipv6 pim {dense-mode | sparse-mode}
dense-mode - Enables PIM Dense Mode.
sparse-mode - Enables PIM Sparse Mode.
– 1951 –
| Multicast Routing Commands
C 52
HAPTER
PIM Multicast Routing
ipv6 pim
command.
ipv6 mld proxy command).
Mode
PE
PE
PE
command, and