Edge-Core ECS4660-28F Management Manual page 1870

Hide thumbs Also See for ECS4660-28F:

Table of Contents

| IP Routing Commands

Border Gateway Protocol (BGPv4)

override-capability

neighbor passive

in same AS will not be able to talk with routers outside of the AS if they

are not directly connected with each other. The neighbor next-hop-

self command can be used to configure an iBGP router which is directly

connected with an eBGP neighbor so that other iBGP routers in the

same AS can talk with eBGP routers outside the AS.

Console(config-router)#neighbor 10.1.1.64 next-hop-self

Console(config-router)#

This command overrides the result of capability negotiations, allowing a

session to be formed with a peer that does not support capability

negotiation. Use the no form to disable this feature.

[no] neighbor {ip-address | group-name}

neighbor override-capability

ip-address – IP address of a neighbor.

group-name – A BGP peer group containing a list of neighboring

routers configured with the

Router Configuration

Console(config-router)#neighbor 10.1.1.64 override-capability

Console(config-router)#

This command passively forms a connection with the specified neighbor,

not sending a TCP connection request, but waiting a connection request

from the specified neighbor. Use the no form to disable this feature.

[no] neighbor {ip-address | group-name} passive