Edge-Core ECS4660-28F Management Manual page 1959

PIM6-DM Commands
ipv6 pim
graft-retry-interval
Table 289: show ipv6 pim neighbor - display description (Continued)
Field Description
The designated PIM6-SM router. If multicast hosts are directly
DR
connected to the LAN, then only one of these routers is elected as
the DR, and acts on behalf of these hosts, sending periodic Join/
Prune messages toward a group-specific RP for each group.
This command configures the time to wait for a Graft acknowledgement
before resending a Graft. Use the no form to restore the default value.
S
YNTAX
ipv6 pim graft-retry-interval seconds
no ipv6 pim graft-retry-interval
seconds - The time before resending a Graft.
(Range: 1-10 seconds)
D S
EFAULT ETTING
3 seconds
C M
OMMAND ODE
Interface Configuration (VLAN)
C U
OMMAND SAGE
A graft message is sent by a router to cancel a prune state. When a router
receives a graft message, it must respond with an graft acknowledgement
message. If this acknowledgement message is lost, the router that sent
the graft message will resend it a number of times (as defined by the
pim max-graft-retries command).
E
XAMPLE
Console(config-if)#ipv6 pim graft-retry-interval 9
Console(config-if)#
R C
ELATED OMMANDS
ipv6 pim override-interval (1955)
ipv6 pim propagation-delay (1956)
– 1959 –
| Multicast Routing Commands
C 52
HAPTER
PIM Multicast Routing
ipv6