Edge-Core ECS4660-28F Management Manual page 1006

| SNMP Commands
C 25
HAPTER
SNMPv3 Commands
snmp-server group
This command adds an SNMP group, mapping SNMP users to SNMP views.
Use the no form to remove an SNMP group.
S
YNTAX
snmp-server group groupname
{v1 | v2c | v3 {auth | noauth | priv}}
[read readview] [write writeview] [notify notifyview]
no snmp-server group groupname
groupname - Name of an SNMP group. (Range: 1-32 characters)
v1 | v2c | v3 - Use SNMP version 1, 2c or 3.
auth | noauth | priv - This group uses SNMPv3 with
authentication, no authentication, or with authentication and
privacy. See "Simple Network Management Protocol" on page 480
for further information about these authentication and encryption
options.
readview - Defines the view for read access. (1-32 characters)
writeview - Defines the view for write access. (1-32 characters)
notifyview - Defines the view for notifications. (1-32 characters)
D S
EFAULT ETTING
Default groups: public
17
readview - Every object belonging to the Internet OID space (1).
writeview - Nothing is defined.
notifyview - Nothing is defined.
C M
OMMAND ODE
Global Configuration
C U
OMMAND SAGE
A group sets the access policy for the assigned users.
◆
When authentication is selected, the MD5 or SHA algorithm is used as
◆
specified in the snmp-server user
◆ When privacy is selected, the DES 56-bit algorithm is used for data
encryption.
For additional information on the notification messages supported by
◆
this switch, see Table 34, "Supported Notification Messages," on
page 490. Also, note that the authentication, link-up and link-down
messages are legacy traps and must therefore be enabled in
conjunction with the
17. No view is defined.
18. Maps to the defaultview.
– 1006 –
(read only), private (read/write)
18
command.
snmp-server enable traps command.