Edge-Core ECS4660-28F Management Manual page 1091

the system, and no dynamic addresses are subsequently learned until
MAC address learning has been re-enabled.
The mac-learning commands cannot be used if 802.1X Port
◆
Authentication has been globally enabled on the switch with the
system-auth-control
enabled by the
E
XAMPLE
The following example disables MAC address learning for port 2.
Console(config)#interface ethernet 1/2
Console(config-if)#no mac-learning
Console(config-if)#
R
ELATED
show interfaces status (1202)
This command enables or configures port security. Use the no form without
port security
any keywords to disable port security. Use the no form with the
appropriate keyword to restore the default settings for a response to
security violation or for the maximum number of allowed addresses.
S
YNTAX
port security [action {shutdown | trap | trap-and-shutdown}
no port security [action | max-mac-count]
D
EFAULT
Status: Disabled
Action: None
Maximum Addresses: 0
C
OMMAND
Interface Configuration (Ethernet)
command, or if MAC Address Security has been
port security
C
OMMANDS
| max-mac-count address-count]
action - Response to take when port security is violated.
shutdown - Disable port only.
trap - Issue SNMP trap message only.
trap-and-shutdown - Issue SNMP trap message and disable
port.
max-mac-count
address-count - The maximum number of MAC addresses that
can be learned on a port. (Range: 0 - 1024, where 0 means
disabled)
S
ETTING
M
ODE
– 1091 –
| General Security Measures
C 29
HAPTER
command on the same interface.
Port Security
dot1x