Edge-Core ECS4660-28F Management Manual page 1205

Transceiver Threshold Configuration
transceiver-
threshold-auto
Table 134: show interfaces switchport - display description (Continued)
Field Description
Allowed VLAN Shows the VLANs this interface has joined, where "(u)" indicates
untagged and "(t)" indicates tagged
Forbidden VLAN Shows the VLANs this interface can not dynamically join via GVRP
(page 1340).
Private-VLAN Shows the private VLAN mode as host, promiscuous, or none (1369).
Mode
Private VLAN host- Shows the secondary (or community) VLAN with which this port is
association associated (1368).
Private VLAN Shows the primary VLAN mapping for a promiscuous port (1370).
mapping
802.1Q-tunnel Shows if 802.1Q tunnel is enabled on this interface
Status
802.1Q-tunnel Shows the tunnel mode as Normal, 802.1Q Tunnel or 802.1Q Tunnel
Mode Uplink (page
802.1Q-tunnel Shows the Tag Protocol Identifier used for learning and switching packets
TPID (page 1358).
Layer 2 Protocol Shows if L2 Protocol Tunnel is enabled for spanning tree protocol
Tunnel (page 1363).
Broadcast Block Shows if the broadcast packets are blocked
Unknown Multicast Shows if the unknown multicast packets are blocked
Block
Unknown Unicast Shows if the unknown unicast packets are blocked
Block
This command uses default threshold settings obtained from the
transceiver to determine when an alarm or warning message should be
sent. Use the no form to disable this feature.
S
YNTAX
transceiver-threshold-auto
D S
EFAULT ETTING
Enabled
C M
OMMAND ODE
Interface Configuration (Ethernet)
E
XAMPLE
Console(config)interface ethernet 1/11
Console(config-if)#transceiver-threshold-auto
Console#
– 1205 –
C
HAPTER
Transceiver Threshold Configuration
(page
1355).
| Interface Commands
31
1347).
(page 1354).
(page 1242).
(page 1242).
(page 1242).