Edge-Core ECS4660-28F Management Manual page 1953

Graft Retry Interval
Max Graft Retries
State Refresh Ori Int
Console#
This command configures the interval to wait for hello messages from a
ipv6 pim
neighboring PIM router before declaring it dead. Use the no form to restore
hello-holdtime
the default value.
S
YNTAX
ipv6 pim hello-holdtime seconds
no ipv6 pim hello-interval
D
EFAULT
105 seconds
C
OMMAND
Interface Configuration (VLAN)
C
OMMAND
The ip pim hello-holdtime should be greater than the value of
hello-interval.
E
XAMPLE
Console(config-if)#ipv6 pim hello-holdtime 210
Console(config-if)#
This command configures the frequency at which PIM hello messages are
ipv6 pim
transmitted. Use the no form to restore the default value.
hello-interval
S
YNTAX
ipv6 pim hello-interval seconds
no pimv6 hello-interval
D
EFAULT
30 seconds
C
OMMAND
Interface Configuration (VLAN)
: 3 sec
: 3
: 60 sec
seconds - The hold time for PIM hello messages. (Range: 1-65535)
S
ETTING
M
ODE
U
SAGE
seconds - Interval between sending PIM hello messages.
(Range: 1-65535)
S
ETTING
M
ODE
– 1953 –
| Multicast Routing Commands
C 52
HAPTER
PIM Multicast Routing
ipv6 pim