Edge-Core ECS4660-28F Management Manual page 1605

◆
N
trap message prior to power down.
E
This command enables reporting of errored frame link events. Use the no
efm oam
form to disable this function.
link-monitor frame
S
D
Enabled
C
Interface Configuration
C
◆
◆
E
This command sets the threshold for errored frame link events. Use the no
efm oam
form to restore the default setting.
link-monitor
frame threshold
S
detected, fan failure, CRC error in flash memory, insufficient memory,
or other hardware faults.
Dying gasp events are caused by an unrecoverable failure, such as a
power failure or device reset.
When system power fails, the switch will always send a dying gasp
:
OTE
XAMPLE
Console(config)#interface ethernet 1/1
Console(config-if)#efm oam critical-link-event dying-gasp
Console(config-if)#
YNTAX
[no] efm oam link-monitor frame
S
EFAULT ETTING
M
OMMAND ODE
U
OMMAND SAGE
An errored frame is a frame in which one or more bits are errored.
If this feature is enabled and an errored frame link event occurs, the
local OAM entity (this switch) sends an Event Notification OAMPDU.
XAMPLE
Console(config)#interface ethernet 1/1
Console(config-if)#efm oam link-monitor frame
Console(config-if)#
YNTAX
[no] efm oam link-monitor frame threshold count
count - The threshold for errored frame link events.
(Range: 1-65535)
– 1605 –
| OAM Commands
C 46
HAPTER