Table of Contents
Advertisement
E
XAMPLE
This example sets the register rate limit to 500 pps.
Console(config)#ipv6 pim register-rate-limit 500
Console(config)#
This command configures the IP source address of a register message to
ipv6 pim
an address other than the outgoing interface address of the designated
register-source
router (DR) that leads back toward the rendezvous point (RP). Use the no
form to restore the default setting.
S
YNTAX
ipv6 pim register-source interface vlan vlan-id
no ipv6 pim register-source
D
EFAULT
The IP address of the DR's outgoing interface that leads back to the RP
C
OMMAND
Global Configuration
C
OMMAND
When the source address of a register message is filtered by intermediate
network devices, or is not a uniquely routed address to which the RP can
send packets, the replies sent from the RP to the source address will fail to
reach the DR, resulting in PIM6-SM protocol failures. This command can be
used to overcome this type of problem by manually configuring the source
address of register messages to an interface that leads back to the RP.
E
XAMPLE
This example sets the register source address to the interface address for
VLAN 1.
Console(config)#ipv6 pim register-source interface vlan 1
Console(config)#
vlan-id - VLAN ID (Range: 1-4094)
S
ETTING
M
ODE
U
SAGE
– 1963 –
| Multicast Routing Commands
C
52
HAPTER
PIM Multicast Routing
Advertisement
Chapters
Table of Contents
