Table 114: Show Port Security - Display Description - Edge-Core ECS4660-28F Management Manual

| General Security Measures
C 29
HAPTER
Port Security
C M
OMMAND ODE
Privileged Exec
E
XAMPLE
This example shows the port security settings and number of secure
addresses for all ports.
Console#show port security
Global Port Security Parameters
Secure MAC Aging Mode : Disabled
Port Security Port Summary
Port Port Security Port Status
--------------------------------------------------------------------------
Eth 1/ 1 Disabled
Eth 1/ 2 Enabled
Eth 1/ 3 Disabled
Eth 1/ 4 Disabled
Eth 1/ 5 Disabled
Eth 1/ 6 Disabled
Eth 1/ 7 Disabled
Eth 1/ 8 Disabled
Eth 1/ 9 Disabled
Eth 1/10 Disabled
Eth 1/11 Disabled
Eth 1/12 Disabled
Console#

Table 114: show port security - display description

Field Description
Port Security The configured status (enabled or disabled).
Port Status The operational status:
Secure/Down – Port security is disabled.
◆
Secure/Up – Port security is enabled.
◆
Shutdown – Port is shut down due to a response to a port security
◆
violation.
Intrusion Action The configured intrusion response.
MaxMacCnt The maximum number of addresses which can be stored in the address
table for this interface (either dynamic or static).
CurrMacCnt The current number of secure entries in the address table.
The following example shows the port security settings and number of
secure addresses for a specific port. The Last Intrusion MAC and Last Time
Detected Intrusion MAC fields show information about the last detected
intrusion MAC address. These fields are not applicable if no intrusion has
been detected or port security is disabled. The MAC Filter ID field is
configured by the network-access port-mac-filter
displays Disabled, then any unknown source MAC address can be learned
as a secure MAC address. If it displays a filter identifier, then only source
– 1094 –
Intrusion Action
Secure/Down None
Secure/Up None
Secure/Down None
Secure/Down None
Secure/Down None
Secure/Down None
Secure/Down None
Secure/Down None
Secure/Down None
Secure/Down None
Secure/Down None
Secure/Down None
MaxMacCnt CurrMacCnt
0 2
10 0
0 0
0 0
0 0
0 0
0 0
0 0
0 0
0 0
0 0
0 0
command. If this field