Edge-Core ECS4660-28F Management Manual page 984

| System Management Commands
C 24
HAPTER
Synchronous Ethernet
synce force-clock-
source-selecting
E
XAMPLE
Console(config)#synce auto-clock-source-selecting revertive-switching
Console(config)#end
Console#show synce
SyncE Status:
Port Status Clock Source
--------- -------- ------------
Eth 1/25 Enabled Yes
Eth 1/26 Disabled No
Eth 1/27 Disabled No
Eth 1/28 Disabled No
SyncE Clock Source Selection Mode: Auto
SyncE Active Clock Source Locked: No
SyncE Clock Source Status:
Port Priority Active Clock Source
--------- -------- -------------------
Eth 1/25 25
...
This command sets the local clock as the active clock source, or sets a port
to be the active clock source.
S
YNTAX
synce force-clock-source-selecting [ethernet unit/port]
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 25-28)
D S
EFAULT ETTING
Disabled
C M
OMMAND ODE
Global Configuration
C U
OMMAND SAGE
If this command is used without specifying a clock source port, and
◆
SyncE has not been enabled on any port, then the local clock is set to
be the active clock source.
If SyncE has been enabled on more than one port, the switch will
◆
choose the clock source port based on the current clock source port
status and priority.
A port can be forced to be the clock source port regardless of the
◆
clock's signal status.
E
XAMPLE
Console(config)#sync ethernet 1/25 clock-source priority 1
Console(config)#
– 984 –
Clock Status
------------
Yes Bad