Edge-Core ECS4660-28F Management Manual page 1028

| Flow Sampling Commands
C 27
HAPTER
sflow polling
instance
E
XAMPLE
This example enables a sampling data source on Ethernet interface 1/1, an
associated receiver named "owner1", and a sampling rate of one out of
100. The maximum header size is also set to 200 bytes.
Console# sflow sampling interface ethernet 1/1 instance 1 receiver owner1
sampling-rate 100 max-header-size 200
Console#
The following command removes a sampling data source from Ethernet
interface 1/1.
Console# no sflow sampling interface ethernet 1/1 instance 1
Console#
This command enables an sFlow polling data source, for a specified
interface, that polls periodically based on a specified time interval. Use the
no form to remove the polling data source instance from the switch's sFlow
configuration.
S
YNTAX
sflow polling {interface interface} instance instance-id
receiver owner-name polling-interval seconds
no sflow polling {interface interface} instance instance-id
interface - The source from which the samples will be taken at
specified intervals and sent to a collector.
ethernet unit/port
unit - Stack unit. (Range: 1)
port - Port number. (Range: 1-28)
instance-id - An instance ID used to identify the sampling source.
(Range: 1)
owner-name - The associated receiver, to which the samples will be
sent. (Range: 1-30 alphanumeric characters)
polling-interval - The time interval at which the sFlow process
adds counter values to the sample datagram. (Range: 0-10000000
seconds, 0 disables this feature)
D S
EFAULT ETTING
No sFlow polling instance is configured.
C M
OMMAND ODE
Privileged Exec
– 1028 –