Edge-Core ECS4660-28F Management Manual page 1234

| Port Mirroring Commands
C 33
HAPTER
RSPAN Mirroring Commands
rspan destination
E
XAMPLE
The following example configures the switch to mirror received packets
from port 2 and 3:
Console(config)#rspan session 1 source interface ethernet 1/2
Console(config)#rspan session 1 source interface ethernet 1/3
Console(config)#
Use this command to specify the destination port to monitor the mirrored
traffic. Use the no form to disable RSPAN on the specified port.
S
YNTAX
rspan session session-id destination interface interface
[tagged | untagged]
no rspan session session-id destination interface interface
session-id – A number identifying this RSPAN session. (Range: 1-2)
Only two mirror sessions are allowed, including both local and
remote mirroring. If local mirroring is enabled with the
command, then there is only one session available for RSPAN.
interface - ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-28)
tagged - Traffic exiting the destination port carries the RSPAN VLAN
tag.
untagged - Traffic exiting the destination port is untagged.
D S
EFAULT ETTING
Traffic exiting the destination port is untagged.
C M
OMMAND ODE
Global Configuration
C U
OMMAND SAGE
◆ Only one destination port can be configured on the same switch per
session, but a destination port can be configured on more than one
switch for the same session.
Only ports can be configured as an RSPAN destination – static and
◆
dynamic trunks are not allowed.
The source port and destination port cannot be configured on the same
◆
switch.
A destination port can still send and receive switched traffic, and
◆
participate in any Layer 2 protocols to which it has been assigned.
– 1234 –
port monitor