Edge-Core ECS4660-28F Management Manual page 1283

This command configures the spanning tree priority globally for this switch.
spanning-tree
Use the no form to restore the default.
priority
S
D
32768
C
Global Configuration
C
Bridge priority is used in selecting the root device, root port, and
designated port. The device with the highest priority (i.e., lower numeric
value) becomes the STA root device. However, if all devices have the same
priority, the device with the lowest MAC address will then become the root
device.
E
This command changes to Multiple Spanning Tree (MST) configuration
spanning-tree
mode.
mst configuration
D
No VLANs are mapped to any MST instance.
The region name is set the switch's MAC address.
C
Global Configuration
E
R
mst vlan (1286)
mst priority (1286)
name (1287)
YNTAX
spanning-tree priority priority
no spanning-tree priority
priority - Priority of the bridge. (Range – 0-61440, in steps of 4096;
Options: 0, 4096, 8192, 12288, 16384, 20480, 24576, 28672,
32768, 36864, 40960, 45056, 49152, 53248, 57344, 61440)
S
EFAULT ETTING
M
OMMAND ODE
U
OMMAND SAGE
XAMPLE
Console(config)#spanning-tree priority 40000
Console(config)#
S
EFAULT ETTING
M
OMMAND ODE
XAMPLE
Console(config)#spanning-tree mst configuration
Console(config-mstp)#
C
ELATED OMMANDS
– 1283 –
| Spanning Tree Commands
C 38
HAPTER