Edge-Core ECS4660-28F Management Manual page 1922

| Multicast Routing Commands
C 52
HAPTER
General Multicast Routing
IPv6 Commands
ipv6
multicast-routing
Table 279: show ip mroute - display description (Continued)
Field Description
IP address of the multicast router immediately upstream for this
RPF neighbor
group.
The interface(s) on which multicast subscribers have been
Outgoing interface
recorded. The flags associated with each interface indicate:
list and flags
◆
◆
◆
This example lists all entries in the multicast table in summary form:
Console#show ip mroute summary
IP Multicast Forwarding is enabled
IP Multicast Routing Table (Summary)
Flags: F – Forwarding,
Group Source
--------------- --------------- --------------- ---------- ------- ------
224.0.17.17 192.168.2.1 255.255.255.255 VLAN2
Total Entry is 1
Console#
This command enables IPv6 multicast routing. Use the no form to disable
IP multicast routing.
S
YNTAX
[no] iv6p multicast-routing
D S
EFAULT ETTING
Disabled
C M
OMMAND ODE
Global Configuration
C U
OMMAND SAGE
This command is used to enable IPv6 multicast routing globally for the
◆
router. A multicast routing protocol also needs to be enabled on the
interfaces that will support multicast routing using the
command, and then specify the interfaces that will support multicast
routing using the ipv6 pim
To use multicast routing, MLD proxy can not enabled on any interface of
◆
the device (see ipv6 mld proxy
– 1922 –
F (Register flag) - This device is registering for a multicast
source.
P (Pruned) - This route has been terminated.
L (Local) - Downstream interface has received IGMP report
message from host in this subnet.
P - Pruned
Source Mask
command.
on page 1534).
Interface Owner Flags
PIM-DM F
router pim6