Edge-Core ECS4660-28F Management Manual page 1528

| Multicast Filtering Commands
C 43
HAPTER
MLD (Layer 3)
ipv6 mld
query-interval
ipv6 mld robustval
This command configures the frequency at which host query messages are
sent. Use the no form to restore the default.
S
YNTAX
ipv6 mld query-interval seconds
no ipv6 mld query-interval
seconds - The frequency at which the switch sends MLD host-query
messages. (Range: 1-255 seconds)
D S
EFAULT ETTING
125 seconds
C M
OMMAND ODE
Interface Configuration (VLAN)
C U
OMMAND SAGE
Multicast routers send host query messages to determine the interfaces
◆
that are connected to downstream hosts requesting a specific multicast
service. Only the designated multicast router for a subnet sends host
query messages, which are addressed to the link-scope all-nodes
multicast address FF02::1, and uses a time-to-live (TTL) value of 1.
◆ The designated querier is the lowest IP-addressed multicast router on
the subnet.
E
XAMPLE
The following shows how to configure the query interval to 100 seconds.
Console(config-if)#ipv6 mld query-interval 100
Console(config-if)#
R C
ELATED OMMANDS
ipv6 mld max-resp-interval (1527)
This command specifies the robustness (expected packet loss) for this
interface. Use the no form of this command to restore the default value.
S
YNTAX
ipv6 mld robustval robust-value
no ipv6 mld robustval
robust-value - The robustness of this interface. (Range: 1-255)
D S
EFAULT ETTING
2
– 1528 –