Edge-Core ECS4660-28F Management Manual page 1194

| Interface Commands
C 31
HAPTER
Interface Configuration
negotiation
shutdown
This command enables auto-negotiation for a given interface. Use the no
form to disable auto-negotiation.
S
YNTAX
[no] negotiation
D S
EFAULT ETTING
Enabled
C M
OMMAND ODE
Interface Configuration (Ethernet, Port Channel)
C U
OMMAND SAGE
When auto-negotiation is enabled the switch will negotiate the best
◆
settings for a link based on the
negotiation is disabled, you must manually specify the link attributes
with the flowcontrol
Note: Auto-negotiation is not supported for 1000BASE SFP transceivers used in
10G SFP+ Ports 51 to 52.
E
XAMPLE
The following example configures port 10 to use auto-negotiation.
Console(config)#interface ethernet 1/10
Console(config-if)#negotiation
Console(config-if)#
R C
ELATED OMMANDS
capabilities (1189)
This command disables an interface. To restart a disabled interface, use
the no form.
S
YNTAX
[no] shutdown
D S
EFAULT ETTING
All interfaces are enabled.
C M
OMMAND ODE
Interface Configuration (Ethernet, Port Channel)
– 1194 –
capabilities
command.
command. When auto-