Edge-Core ECS4660-28F Management Manual page 1709

This command sets the maximum number of address entries in the
ipv6 nd snooping
dynamic user binding table which can be bound to a port. Use the no form
max-binding
to restore the default setting.
S
YNTAX
D
5
C
Interface Configuration (Ethernet, Port Channel)
E
XAMPLE
This command configures a port as a trusted interface from which prefix
ipv6 nd snooping
information in RA messages can be added to the prefix table, or NS
trust
messages can be forwarded without validation. Use the no form to restore
the default setting.
S
YNTAX
D
Not trusted
C
Interface Configuration (Ethernet, Port Channel)
C
◆
◆
◆
ipv6 nd snooping max-binding max-bindings
no ipv6 nd snooping max-binding
max-bindings – The maximum number of address entries in the
dynamic user binding table which can be bound to a port.
(Range: 1-5)
S
EFAULT ETTING
M
OMMAND ODE
Console(config)#ipv6 nd snooping prefix timeout 200
Console(config)#
[no] ipv6 nd snooping trust
S
EFAULT ETTING
M
OMMAND ODE
U
OMMAND SAGE
In general, interfaces facing toward to the network core, or toward
routers supporting the Network Discovery protocol, are configured as
trusted interfaces.
RA messages received from a trusted interface are added to the prefix
table and forwarded toward their destination.
NS messages received from a trusted interface are forwarded toward
their destination. Nothing is added to the dynamic user binding table.
– 1709 –
| IP Interface Commands
C 49
HAPTER
ND Snooping