Edge-Core ECS4660-28F Management Manual page 1003

Hide thumbs Also See for ECS4660-28F:

Table of Contents

snmp-server enable traps (1000)

This command enables the device to send SNMP traps (i.e., SNMP

notifications) when a dynamic MAC address is added or removed. Use the

enable port-traps

no form to restore the default setting.

mac-notification

Interface Configuration (Ethernet, Port Channel)

This command can enable MAC authentication traps on the current

interface only if they are also enabled at the global level with the

server enable traps mac-authentication

To send an inform to a SNMPv3 host, complete these steps:

Enable the SNMP agent

Create a local SNMPv3 user to use in the message exchange

Create a view with the required notification messages

Create a group that includes the required notify view

Allow the switch to send SNMP traps; i.e., notifications

Specify the target host that will receive inform messages with the

snmp-server host command as described in this section.

The switch can send SNMP Version 1, 2c or 3 notifications to a host IP

address, depending on the SNMP version that the management station

supports. If the snmp-server host command does not specify the

SNMP version, the default is to send SNMP version 1 notifications.

If you specify an SNMP Version 3 host, then the community string is

interpreted as an SNMP user name. The user name must first be

defined with the

snmp-server user

group will be automatically created by the snmp-server host

command using the name of the specified community string, and

default settings for the read, write, and notify view.

Console(config)#snmp-server host 10.1.19.23 batman

Console(config)#

[no] snmp-server enable port-traps mac-notification

mac-notification - Keyword to issue trap when a dynamic MAC

address is added or removed.

SNMP Target Host Commands

command. Otherwise, an SNMPv3

| SNMP Commands

Chapters

Table of Contents