Edge-Core ECS4660-28F Management Manual page 1859

Neighbor Configuration
neighbor activate
neighbor
advertisement-
interval
This command enables the exchange of routing information with a
neighboring router or peer group. Use the no form to disable the exchange
of routing information.
S
YNTAX
[no] neighbor {ip-address | group-name} activate
ip-address – IP address of a neighbor.
group-name – A BGP peer group containing a list of neighboring
routers configured with the
C M
OMMAND ODE
Router Configuration
D S
EFAULT ETTING
Enabled
C U
OMMAND SAGE
After a connection is opened with a neighboring router, this command is
◆
used to enable the exchange of information with the neighbor.
The exchange of information is enabled by default for each routing
◆
session configured with the
E
XAMPLE
Console(config-router)#neighbor 10.1.1.64 activate
Console(config-router)#
This command configures the interval between sending update messages
to a neighbor. Use the no form to restore the default setting.
S
YNTAX
neighbor ip-address advertisement-interval interval
no neighbor ip-address advertisement-interval
ip-address – IP address of a neighbor.
interval – The minimum interval between sending routing updates
to the specified neighbor. (Range: 0-600 seconds)
C M
OMMAND ODE
Router Configuration
D S
EFAULT ETTING
iBGP: 5 seconds
eBGP: 30 seconds
– 1859 –
| IP Routing Commands
C 51
HAPTER
Border Gateway Protocol (BGPv4)
neighbor peer-group
neighbor remote-as command.
command.