Edge-Core ECS4660-28F Management Manual page 1608

| OAM Commands
C 46
HAPTER
clear efm oam
event-log
efm oam
remote-loopback
R C
ELATED OMMANDS
show efm oam counters interface (1610)
This command clears all entries from the OAM event log for the specified
port.
S
YNTAX
clear efm oam event-log [interface-list]
unit - Unit identifier. (Range: 1)
port - Port number or list of ports. To enter a list, separate
nonconsecutive port identifiers with a comma and no spaces; use a
hyphen to designate a range of ports. (Range: 1-28)
C M
OMMAND ODE
Privileged Exec
E
XAMPLE
Console#clear efm oam event-log
Console#
This command starts or stops OAM loopback test mode to the attached
CPE.
S
YNTAX
efm oam remote-loopback {start | stop} interface
start - Starts remote loopback test mode.
stop - Stops remote loopback test mode.
interface - unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-28)
D S
EFAULT ETTING
None
C M
OMMAND ODE
Privileged Exec
C U
OMMAND SAGE
OAM remote loop back can be used for fault localization and link
◆
performance testing. Statistics from both the local and remote DTE can
be queried and compared at any time during loop back testing.
◆ Use the efm oam remote-loopback start command to start OAM
remote loop back test mode on the specified port. Afterwards, use the
– 1608 –