Edge-Core ECS4660-28F Management Manual page 1665

Hide thumbs Also See for ECS4660-28F:

Table of Contents

An IPv6 default gateway should be defined if the destination has been

assigned an IPv6 address that is located in a different IP segment.

An IPv6 default gateway can only be successfully set when a network

interface that directly connects to the gateway has been configured on

The following example defines a default gateway for this device:

Console(config)#ipv6 default-gateway FE80::269:3EF9:FE19:6780%1

Console(config)#

show ipv6 route (1731)

ip default-gateway (1650)

This command configures an IPv6 global unicast address and enables IPv6

ipv6 address

on an interface. Use the no form without any arguments to remove all IPv6

addresses from the interface, or use the no form with a specific IPv6

address to remove that address from the interface.

[no] ipv6 address ipv6-address[/prefix-length]

No IPv6 addresses are defined

Interface Configuration (VLAN, IPv6/v4 Tunnel)

All IPv6 addresses must be according to RFC 2373 "IPv6 Addressing

Architecture," using 8 colon-separated 16-bit hexadecimal values. One

double colon may be used in the address to indicate the appropriate

number of zeros required to fill the undefined fields.

To connect to a larger network with multiple subnets, you must

configure a global unicast address. This address can be manually

configured with this command.

If a link-local address has not yet been assigned to this interface, this

command will assign the specified static global unicast address and also

dynamically generate a link-local unicast address for the interface. (The

ipv6-address - A full IPv6 address including the network prefix and

host address bits.

prefix-length - A decimal value indicating how many contiguous bits

(from the left) of the address comprise the prefix (i.e., the network

portion of the address).

| IP Interface Commands

IPv6 Interface

Chapters

Table of Contents