Edge-Core ECS4660-28F Management Manual page 1013

Hide thumbs Also See for ECS4660-28F:

Table of Contents

Disabling logging with this command does not delete the entries stored

in the notification log.

This example enables the notification log A1.

Console(config)#nlm A1

Console(config)#

This command creates an SNMP notification log. Use the no form to

remove this log.

notify-filter

[no] snmp-server notify-filter profile-name remote ip-address

The notification log is stored locally. It is not sent to a remote

device. This remote host parameter is only required to complete

mandatory fields in the SNMP Notification MIB.

Global Configuration

Systems that support SNMP often need a mechanism for recording

Notification information as a hedge against lost notifications, whether

there are Traps or Informs that may be exceeding retransmission limits.

The Notification Log MIB (NLM, RFC 3014) provides an infrastructure in

which information from other MIBs may be logged.

Given the service provided by the NLM, individual MIBs can now bear

less responsibility to record transient information associated with an

event against the possibility that the Notification message is lost, and

applications can poll the log to verify that they have not missed any

important Notifications.

If notification logging is not configured and enabled, when the switch

reboots, some SNMP traps (such as warm start) cannot be logged.

profile-name - Notification log profile name. (Range: 1-32

ip-address - The Internet address of a remote device. The specified

target host must already have been configured using the

| SNMP Commands

Notification Log Commands

Chapters

Table of Contents