Edge-Core ECS4660-28F Management Manual page 1350

| VLAN Commands
C 40
HAPTER
Configuring VLAN Interfaces
switchport
native vlan
vlan-trunking
This command configures the PVID (i.e., default VLAN ID) for a port. Use
the no form to restore the default.
S
YNTAX
switchport native vlan vlan-id
no switchport native vlan
vlan-id - Default VLAN ID for a port. (Range: 1-4094)
D S
EFAULT ETTING
VLAN 1
C M
OMMAND ODE
Interface Configuration (Ethernet, Port Channel)
C U
OMMAND SAGE
When using Access mode, and an interface is assigned to a new VLAN,
◆
its PVID is automatically set to the identifier for that VLAN. When using
Hybrid mode, the PVID for an interface can be set to any VLAN for
which it is an untagged member.
If acceptable frame types is set to all or switchport mode is set to
◆
hybrid, the PVID will be inserted into all untagged frames entering the
ingress port.
E
XAMPLE
The following example shows how to set the PVID for port 1 to VLAN 3:
Console(config)#interface ethernet 1/1
Console(config-if)#switchport native vlan 3
Console(config-if)#
This command allows unknown VLAN groups to pass through the specified
interface. Use the no form to disable this feature.
S
YNTAX
[no] vlan-trunking
D S
EFAULT ETTING
Disabled
C M
OMMAND ODE
Interface Configuration (Ethernet, Port Channel)
C U
OMMAND SAGE
Use this command to configure a tunnel across one or more
◆
intermediate switches which pass traffic for VLAN groups to which they
do not belong.
– 1350 –