Edge-Core ECS4660-28F Management Manual page 1236

| Port Mirroring Commands
C 33
HAPTER
RSPAN Mirroring Commands
no rspan session
show rspan
Only one uplink port can be configured on a source switch, but there is
◆
no limitation on the number of uplink ports configured on an
intermediate or destination switch.
Only destination and uplink ports will be assigned by the switch as
◆
members of this VLAN. Ports cannot be manually assigned to an RSPAN
VLAN with the switchport allowed vlan
dynamically add port members to an RSPAN VLAN. Also, note that the
show vlan command will not display any members for an RSPAN VLAN,
but will only show configured RSPAN VLAN identifiers.
E
XAMPLE
The following example enables RSPAN on VLAN 2, specifies this device as
an RSPAN destination switch, and the uplink interface as port 3:
Console(config)#rspan session 1 remote vlan 2 destination uplink ethernet 1/3
Console(config)#
Use this command to delete a configured RSPAN session.
S
YNTAX
no rspan session session-id
session-id – A number identifying this RSPAN session. (Range: 1-2)
Only two mirror sessions are allowed, including both local and
remote mirroring. If local mirroring is enabled with the
command, then there is only one session available for RSPAN.
C M
OMMAND ODE
Global Configuration
C U
OMMAND SAGE
The no rspan session command must be used to disable an RSPAN VLAN
before it can be deleted from the VLAN database (see the
E
XAMPLE
Console(config)#no rspan session 1
Console(config)#
Use this command to displays the configuration settings for an RSPAN
session.
S
YNTAX
show rspan session [session-id]
session-id – A number identifying this RSPAN session. (Range: 1-2)
– 1236 –
command. Nor can GVRP
port monitor
vlan command).