Edge-Core ECS4660-28F Management Manual page 1447

This command statically configures a (Layer 2) multicast router port on the
ip igmp snooping
specified VLAN. Use the no form to remove the configuration.
vlan mrouter
S
D
No static multicast router ports are configured.
C
Global Configuration
C
◆
◆
E
The following shows how to configure port 10 as a multicast router port
within VLAN 1.
This command displays information on statically configured and
show ip igmp
dynamically learned multicast router ports.
snooping mrouter
S
D
Displays multicast router ports for all configured VLANs.
YNTAX
[no] ip igmp snooping vlan vlan-id mrouter interface
vlan-id - VLAN ID (Range: 1-4094)
interface
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-28)
port-channel channel-id (Range: 1-8)
S
EFAULT ETTING
M
OMMAND ODE
U
OMMAND SAGE
Depending on your network connections, IGMP snooping may not
always be able to locate the IGMP querier. Therefore, if the IGMP
querier is a known multicast router or switch connected over the
network to an interface (port or trunk) on this switch, that interface can
be manually configured to join all the current multicast groups.
IGMP Snooping must be enabled globally on the switch (using the
igmp snooping command) before a multicast router port can take
effect.
XAMPLE
Console(config)#ip igmp snooping vlan 1 mrouter ethernet 1/10
Console(config)#
YNTAX
show ip igmp snooping mrouter [vlan vlan-id]
vlan-id - VLAN ID (Range: 1-4094)
S
EFAULT ETTING
– 1447 –
| Multicast Filtering Commands
C 43
HAPTER
Static Multicast Routing
ip