Edge-Core ECS4660-28F Management Manual page 1955

Layer 3
Hide thumbs Also See for ECS4660-28F:
Table of Contents

Advertisement

C
OMMAND
Interface Configuration (VLAN)
C
OMMAND
E
XAMPLE
Console(config-if)#ipv6 pim lan-prune-delay
Console(config-if)#
R
ELATED
ipv6 pim override-interval (1955)
ipv6 pim propagation-delay (1956)
This command configures the override interval, or the time it takes a
ipv6 pim
downstream router to respond to a lan-prune-delay message. Use the no
override-interval
form to restore the default setting.
S
YNTAX
D
EFAULT
2500 milliseconds
C
OMMAND
Interface Configuration (VLAN)
C
OMMAND
The override interval configured by this command and the propagation
delay configured by the
calculate the LAN prune delay. If a downstream router has group members
which want to continue receiving the flow referenced in a LAN prune delay
M
ODE
U
SAGE
When other downstream routers on the same VLAN are notified that
this upstream router has received a prune request, they must send a
Join to override the prune before the prune delay expires if they want
to continue receiving the flow. The message generated by this
command effectively prompts any downstream neighbors with hosts
receiving the flow to reply with a Join message. If no join messages are
received after the prune delay expires, this router will prune the flow.
Prune delay is the sum of the effective propagation-delay and effective
override-interval, where effective propagation-delay is the largest
propagation-delay from those advertised by each neighbor (including
this switch), and effective override-interval is the largest override-
interval from those advertised by each neighbor (including this switch).
C
OMMANDS
ipv6 pim override-interval milliseconds
no ipv6 pim override-interval
milliseconds - The time required for a downstream router to
respond to a lan-prune-delay message by sending back a Join
message if it wants to continue receiving the flow referenced in the
message. (Range: 500-6000 milliseconds)
S
ETTING
M
ODE
U
SAGE
ipv6 pim propagation-delay
– 1955 –
| Multicast Routing Commands
C
52
HAPTER
PIM Multicast Routing
command are used to

Advertisement

Table of Contents
loading

Table of Contents