Table 166: Vlan Translation Commands - Edge-Core ECS4660-28F Management Manual

| VLAN Commands
C 40
HAPTER
Configuring VLAN Translation
show
l2protocol-tunnel
C VLAN T
ONFIGURING
switchport
vlan-translation
This command shows settings for Layer 2 Protocol Tunneling (L2PT).
C M
OMMAND ODE
Privileged Exec
E
XAMPLE
Console#show l2protocol-tunnel
Layer 2 Protocol Tunnel
Tunnel MAC Address : 01-12-CF-00-00-00
Interface Protocol
----------------------------------------------------------
Eth 1/ 1 Spanning Tree
Console#
RANSLATION
QinQ tunneling uses double tagging to preserve the customer's VLAN tags
on traffic crossing the service provider's network. However, if any switch in
the path crossing the service provider's network does not support this
feature, then the switches directly connected to that device can be
configured to swap the customer's VLAN ID with the service provider's
VLAN ID for upstream traffic, or the service provider's VLAN ID with the
customer's VLAN ID for downstream traffic.
This section describes commands used to configure VLAN translation.

Table 166: VLAN Translation Commands

Command Function
switchport Maps VLAN IDs between the customer and service
vlan-translation provider
show vlan-translation Displays the configuration settings for VLAN
translation
This command maps VLAN IDs between the customer and service provider.
S
YNTAX
switchport vlan-translation original-vlan new-vlan
no switchport vlan-translation original-vlan
original-vlan - The original VLAN ID. (Range: 1-4094)
new-vlan - The new VLAN ID. (Range: 1-4094)
D S
EFAULT ETTING
Disabled
– 1364 –
Mode
IC
PE