Edge-Core ECS4660-28F Management Manual page 1937

ip pim
max-graft-retries
ip pim state-refresh
origination-interval
C U
OMMAND SAGE
A graft message is sent by a router to cancel a prune state. When a router
receives a graft message, it must respond with an graft acknowledgement
message. If this acknowledgement message is lost, the router that sent
the graft message will resend it a number of times (as defined by the
pim max-graft-retries command).
E
XAMPLE
Console(config-if)#ip pim graft-retry-interval 9
Console(config-if)#
This command configures the maximum number of times to resend a Graft
message if it has not been acknowledged. Use the no form to restore the
default value.
S
YNTAX
ip pim max-graft-retries retries
no ip pim max-graft-retries
retries - The maximum number of times to resend a Graft.
(Range: 1-10)
D S
EFAULT ETTING
3
C M
OMMAND ODE
Interface Configuration (VLAN)
E
XAMPLE
Console(config-if)#ip pim max-graft-retries 5
Console(config-if)#
This command sets the interval between sending PIM-DM state refresh
control messages. Use the no form to restore the default value.
S
YNTAX
ip pim state-refresh origination-interval seconds
no ip pim max-graft-retries
seconds - The interval between sending PIM-DM state refresh
control messages. (Range: 1-100 seconds)
D S
EFAULT ETTING
60 seconds
– 1937 –
| Multicast Routing Commands
C 52
HAPTER
PIM Multicast Routing
ip