Edge-Core ECS4660-28F Management Manual page 991

Hide thumbs Also See for ECS4660-28F:

Table of Contents

Once a switch has been configured to be a cluster Commander, it

automatically discovers other cluster-enabled switches in the network.

These "Candidate" switches only become cluster Members when

manually selected by the administrator through the management

Cluster Member switches can be managed through a Telnet connection

to the Commander. From the Commander CLI prompt, use the

Console(config)#cluster commander

Console(config)#

This command sets the cluster IP address pool. Use the no form to reset to

cluster ip-pool

the default address.

cluster ip-pool ip-address

no cluster ip-pool

10.254.254.1

Global Configuration

An "internal" IP address pool is used to assign IP addresses to Member

switches in the cluster. Internal cluster IP addresses are in the form

10.x.x.member-ID. Only the base IP address of the pool needs to be

set since Member IDs can only be between 1 and 36.

Set a Cluster IP Pool that does not conflict with addresses in the

network IP subnet. Cluster IP addresses are assigned to switches when

they become Members and are used for communication between

Member switches and the Commander.

You cannot change the cluster IP pool when the switch is currently in

Commander mode. Commander mode must first be disabled.

Console(config)#cluster ip-pool 10.2.3.4

Console(config)#

command to connect to the Member switch.

ip-address - The base IP address for IP addresses assigned to

cluster Members. The IP address must start 10.x.x.x.

| System Management Commands

Switch Clustering

Chapters

Table of Contents