Edge-Core ECS4660-28F Management Manual page 1871

neighbor
peer-group
(Creating)
D S
EFAULT ETTING
Disabled
C U
OMMAND SAGE
This command configures the local router so that it remains in Active state,
waiting for an inbound connection request from a neighbor, and not
initiating any outbound connections with the neighbor via an Open
message.
E
XAMPLE
Console(config-router)#neighbor 10.1.1.64 passive
Console(config-router)#
This command configures a router peer group which can be easily
configured with the same attributes. Use the no form to remove a peer
group.
S
YNTAX
[no] neighbor group-name peer-group
group-name – A BGP peer group. (Range: 1-256 characters)
C M
OMMAND ODE
Router Configuration
D S
EFAULT ETTING
No peer groups are defined.
C U
OMMAND SAGE
Neighbors with the same BGP attributes can grouped into peer groups.
◆
This simplifies the application of various policies, such as filter lists.
Other configuration settings can be applied to a peer-group using any
of the neighbor commands. Any changes made to the peer group affect
all members.Use this command to create a peer-group.
To assign members to a peer group, use the
◆
group group-name
E
XAMPLE
Console(config-router)#neighbor RD peer-group
Console(config-router)#
– 1871 –
C
HAPTER
Border Gateway Protocol (BGPv4)
command.
| IP Routing Commands
51
neighbor ip-address peer-