Edge-Core ECS4660-28F Management Manual page 1359

◆
E
R
show interfaces switchport (1203)
This command displays information about QinQ tunnel ports.
show dot1q-tunnel
S
C
Privileged Exec
E
The specified ethertype only applies to ports configured in Uplink mode
using the switchport dot1q-tunnel mode
normal mode (i.e, unspecified), the TPID is always 8100. If the port is
in Access mode, received packets are processes as untagged packets.
XAMPLE
Console(config)#interface ethernet 1/1
Console(config-if)#switchport dot1q-tunnel tpid 9100
Console(config-if)#
C
ELATED OMMANDS
YNTAX
show dot1q-tunnel [interface interface [service svid] |
service [svid]]
interface
ethernet unit/port
unit - Stack unit. (Range: 1)
port - Port number. (Range: 1-28)
port-channel channel-id (Range: 1-8)
svid - VLAN ID for the outer VLAN tag (SPVID). (Range: 1-4094)
M
OMMAND ODE
XAMPLE
Console(config)#dot1q-tunnel system-tunnel-control
Console(config)#interface ethernet 1/1
Console(config-if)#switchport dot1q-tunnel mode access
Console(config-if)#interface ethernet 1/2
Console(config-if)#switchport dot1q-tunnel mode uplink
Console(config-if)#end
Console#show dot1q-tunnel
802.1Q Tunnel Status : Enabled
Port Mode TPID (hex)
-------- ------ ----------
Eth 1/ 1 Access 8100
Eth 1/ 2 Uplink 8100
Eth 1/ 3 Normal 8100
. .
.
Console#show dot1q-tunnel interface ethernet 1/5
802.1Q Tunnel Service Subscriptions
Port Match C-VID S-VID Remove C-Tag
-------- ----------- ----- ------------
Eth 1/ 5 1
– 1359 –
C
HAPTER
Configuring IEEE 802.1Q Tunneling
command. If the port is in
100 Disabled
| VLAN Commands
40