Edge-Core ECS4660-28F Management Manual page 1880

| IP Routing Commands
C 51
HAPTER
Border Gateway Protocol (BGPv4)
neighbor strict-
capability-match
neighbor timers
To use soft reconfiguration, without preconfiguration, both BGP
◆
neighbors must support the soft route refresh capability advertised in
open messages sent when a BGP session is established. To see if a BGP
router supports this capability, use the
command.
E
XAMPLE
Console(config-router)#neighbor 11.1.1.120 soft-reconfiguration inbound
Console(config-router)#
This command forces strict capability matching when establishing
connections. Use the no form to disable this requirement.
S
YNTAX
[no] neighbor {ip-address | group-name} strict-capability-match
ip-address – IP address of a neighbor.
group-name – A BGP peer group containing a list of neighboring
routers configured with the
C M
OMMAND ODE
Router Configuration
D S
EFAULT ETTING
Disabled
C U
OMMAND SAGE
This command specifies that a connection can only be established when the
both sides have perfectly matching capabilities.
E
XAMPLE
Console(config-router)#neighbor 10.1.1.66 strict-capability-match
Console(config-router)#
This command sets the Keep Alive time and Hold time used for specified
neighbors. Use the no form to restore the default settings.
S
YNTAX
[no] neighbor {ip-address | group-name} timers keepalive-time
hold-time
ip-address – IP address of a neighbor.
group-name – A BGP peer group containing a list of neighboring
routers configured with the
keepalive-time – The frequency at which the local router sends
keep-alive messages to its neighbors. (Range: 0-65535 seconds)
– 1880 –
show ip bgp neighbors
neighbor peer-group command.
neighbor peer-group command.