Edge-Core ECS4660-28F Management Manual page 1881

Hide thumbs Also See for ECS4660-28F:

Table of Contents

Router Configuration

Keep Alive time: 60 seconds

Hold time: 180 seconds

This command sets the Keep Alive time used for maintaining

connectivity, and the Hold time to wait for Keep Alive or Update

messages before declaring a neighbor down.

This command sets timers for monitoring connectivity to specific

neighboring routers, which supercede those applied to all neighbors

with the global

Console(config-router)#neighbor 10.1.1.66 timers 50 200

Console(config-router)#

This command sets the time to wait before attempting to reconnect to a

neighbor whose TCP connection has failed. Use the no form to restore the

timers connect

default setting.

[no] neighbor ip-address timers connect retry-interval

Router Configuration

hold-time – The maximum interval after which a neighbor is

declared dead if a keep-alive or update message has not been

received. (Range: 0, 3-65535 seconds)

ip-address – IP address of a neighbor.

group-name – A BGP peer group containing a list of neighboring

routers configured with the

retry-interval – The amount of time the system waits for the

transport protocol connection to complete. If this timer expires, the

state remains in Connect state, the timer is reset, and the system

tries to initiate a new transport connection. (Range: 0-65535

| IP Routing Commands

Border Gateway Protocol (BGPv4)

neighbor peer-group

Chapters

Table of Contents