Edge-Core ECS4660-28F Management Manual page 1362

| VLAN Commands
C 40
HAPTER
Configuring L2CP Tunneling
with destination address 01-80-C2-00-00-01~0A (S-VLAN), the
■
frame is filtered, decapsulated, and processed locally by the switch
if the protocol is supported.
Processing Cisco-compatible protocol packets
When a Cisco-compatible L2PT packet is received on an uplink port, and
◆
recognized as a CDP/VTP/STP/PVST+ protocol packet (where STP
■
means STP/RSTP/MSTP), it is forwarded to the following ports in the
same S-VLAN: (a) all access ports for which L2PT has been
disabled, and (b) all uplink ports.
recognized as a Generic Bridge PDU Tunneling (GBPT) protocol
■
packet (i.e., having the destination address 01-00-0C-CD-CD-D0),
it is forwarded to the following ports in the same S-VLAN:
other access ports for which L2PT is enabled after decapsulating
■
the packet and restoring the proper protocol and MAC address
information.
all uplink ports.
■
When a Cisco-compatible L2PT packet is received on an access port,
◆
and
recognized as a CDP/VTP/STP/PVST+ protocol packet, and
■
L2PT is enabled on this port, it is forwarded to the following
■
ports in the same S-VLAN: (a) other access ports for which L2PT
is enabled, and (b) uplink ports after rewriting the destination
address to make it a GBPT protocol packet (i.e., setting the
destination address to 01-00-0C-CD-CD-D0).
L2PT is disabled on this port, it is forwarded to the following
■
ports in the same S-VLAN: (a) other access ports for which L2PT
is disabled, and (b) all uplink ports.
recognized as a GBPT protocol packet (i.e., having the destination
■
address 01-00-0C-CD-CD-D0), and
L2PT is enabled on this port, it is forwarded to other access
■
ports in the same S-VLAN for which L2PT is enabled
L2PT is disabled on this port, it is forwarded to the following
■
ports in the same S-VLAN: (a) other access ports for which L2PT
is disabled, and (b) all uplink ports.
For L2PT to function properly, QinQ must be enabled on the switch
◆
using the dot1q-tunnel system-tunnel-control
interface configured to 802.1Q tunnel mode using the
dot1q-tunnel mode
– 1362 –
command.
command, and the
switchport