Edge-Core ECS4660-28F Management Manual page 1433

C
Global Configuration
C
Once the table used to store multicast entries for IGMP snooping and
multicast routing is filled, no new entries are learned. If no router port is
configured in the attached VLAN, and unregistered-flooding is disabled,
any subsequent multicast traffic not found in the table is dropped,
otherwise it is flooded throughout the VLAN.
E
This command specifies how often the upstream interface should transmit
ip igmp snooping
unsolicited IGMP reports when proxy reporting is enabled. Use the no form
unsolicited-report-
to restore the default value.
interval
S
D
400 seconds
C
Global Configuration
C
◆
◆
E
M
OMMAND ODE
U
OMMAND SAGE
XAMPLE
Console(config)#ip igmp snooping unregistered-data-flood
Console(config)#
YNTAX
ip igmp snooping unsolicited-report-interval seconds
no ip igmp snooping version-exclusive
seconds - The interval at which to issue unsolicited reports.
(Range: 1-65535 seconds)
S
EFAULT ETTING
M
OMMAND ODE
U
OMMAND SAGE
When a new upstream interface (that is, uplink port) starts up, the
switch sends unsolicited reports for all currently learned multicast
channels out through the new upstream interface.
This command only applies when proxy reporting is enabled (see
page 1428).
XAMPLE
Console(config)#ip igmp snooping unsolicited-report-interval 5
Console(config)#
– 1433 –
| Multicast Filtering Commands
C 43
HAPTER
IGMP Snooping