Edge-Core ECS4660-28F Management Manual page 1899

Table 276: Policy-based Routing Configuration Commands (Continued)
Command
set community
set extcommunity
set ip next-hop
set local-preference
set metric
set origin
set originator-id
set pathlimit ttl
set weight
show route-map
This command enters route-map configuration mode, allowing route maps
route-map
to be created or modified. Use the no form to remove a route map.
S
YNTAX
[no] route-map map-name {deny | permit} sequence-number
map-name – Name for the route map. (Range: 1-128 case-sensitive
alphanumeric characters)
deny – Route-map denies set operations.
permit – Route-map permits set operations.
sequence-number – Sequence to insert to or delete from existing
route-map entry. (Range: 1-65535)
C
OMMAND
Global Configuration
D S
EFAULT
Disabled
C
OMMAND
This command enters the route map configuration mode. In this mode,
◆
a new route map can be created, or an existing route map modified.
The match commands specify the conditions under which policy routing
◆
occurs, and the set commands specify the routing actions to perform if
the criteria enforced by the match commands are met.
If the match criteria are met for a route map, and the permit keyword
◆
specified, the packet is policy routed based on defined set commands.
Function
Sets the community attributes of routing messages
Sets the extended community attributes of routing
messages
Sets the next-hop for a routing message
Sets the priority within the local AS for a routing
message
Sets the metric value of a route to external neighbors RM
Sets the origin code for the routing protocol which
generated this message
Sets the IP address of the routing message's originator RM
Sets the maximum AS path length for propagation of
more specific prefixes in routing messages
Sets the weight for routing messages
Shows the configuration setting for a route map
M
ODE
ETTING
U
SAGE
– 1899 –
| IP Routing Commands
C 51
HAPTER
Policy-based Routing for BGP
Mode
RM
RM
RM
RM
RM
RM
RM
PE