Table of Contents
Advertisement
E
XAMPLE
Console(config)#route-map RD permit 5
Console(config-route-map)#match ip next-hop rd-next-hops
Console(config-route-map)#set weight 30
Console(config-route-map)#
This command specifies the source of routing messages advertised by
match ip
routers and access servers to be matched in a standard access list, an
route-source
extended access list, or a prefix list. Use the no form to remove this entry
from a route map.
S
YNTAX
match ip route-source {access-list-name |
no match ip route-source [access-list-name | prefix-list]
C
OMMAND
Route Map
C
OMMAND
Note that there may be situations in which the next hop and source router
address of the route are not the same.
E
XAMPLE
Console(config)#route-map RD permit 6
Console(config-route-map)#match ip route-source rd-sources
Console(config-route-map)#set weight 30
Console(config-route-map)#
This command sets the metric value to match in routing messages. Use the
match metric
no form to remove this entry from a route map.
S
YNTAX
match metric metric-value
no match metric
C
OMMAND
Route Map
prefix-list prefix-list-name}
access-list-name – Name of standard or extended access list.
(Maximum length: 32 characters, no spaces or other special
characters)
prefix-list-name – Name of a specific prefix list.
M
ODE
U
SAGE
metric-value – The metric value in the routing messages.
(Range: 0-4294967295)
M
ODE
– 1905 –
| IP Routing Commands
C
51
HAPTER
Policy-based Routing for BGP
Advertisement
Chapters
Table of Contents
