Edge-Core ECS4660-28F Management Manual page 1053

This command specifies the UDP port number used for HTTPS connection to
ip http secure-port
the switch's web interface. Use the no form to restore the default port.
S
D
443
C
Global Configuration
C
◆
◆
E
R
ip http secure-server (1053)
show system (906)
This command enables the secure hypertext transfer protocol (HTTPS) over
ip http
the Secure Socket Layer (SSL), providing secure access (i.e., an encrypted
secure-server
connection) to the switch's web interface. Use the no form to disable this
function.
S
D
Enabled
C
Global Configuration
YNTAX
ip http secure-port port_number
no ip http secure-port
port_number – The UDP port used for HTTPS. (Range: 1-65535)
S
EFAULT ETTING
M
OMMAND ODE
U
OMMAND SAGE
You cannot configure the HTTP and HTTPS servers to use the same
port.
If you change the HTTPS port number, clients attempting to connect to
the HTTPS server must specify the port number in the URL, in this
format: https://device:port_number
XAMPLE
Console(config)#ip http secure-port 1000
Console(config)#
C
ELATED OMMANDS
YNTAX
[no] ip http secure-server
S
EFAULT ETTING
M
OMMAND ODE
– 1053 –
| Authentication Commands
C 28
HAPTER
Web Server