Table 129: Ipv6 Acl Commands - Edge-Core ECS4660-28F Management Manual

| Access Control Lists
C 30
HAPTER
IPv6 ACLs
IP 6 ACL
V S
access-list ipv6
E
XAMPLE
Console#show ip access-list standard
IP standard access-list david:
permit host 10.1.1.21
permit 168.92.0.0 255.255.15.0
Console#
R C
ELATED OMMANDS
permit, deny (1165)
ip access-group (1168)
The commands in this section configure ACLs based on IPv6 address,
DSCP traffic class, next header type, or flow label. To configure IPv6 ACLs,
first create an access list containing the required permit or deny rules, and
then bind the access list to one or more ports.

Table 129: IPv6 ACL Commands

Command Function
access-list ipv6 Creates an IPv6 ACL and enters configuration mode for
standard or extended IPv6 ACLs
permit, deny Filters packets matching a specified source IPv6
address
permit, deny Filters packets meeting the specified criteria, including
destination IPv6 address, DSCP traffic class, next
header type, or flow label
ipv6 access-group Adds a port to an IPv6 ACL
show ipv6 access-group Shows port assignments for IPv6 ACLs
show ipv6 access-list Displays the rules for configured IPv6 ACLs
This command adds an IP access list and enters configuration mode for
standard or extended IPv6 ACLs. Use the no form to remove the specified
ACL.
S
YNTAX
[no] access-list ipv6 {standard | extended} acl-name
standard – Specifies an ACL that filters packets based on the
source IP address.
extended – Specifies an ACL that filters packets based on the
destination IP address, and other more specific criteria.
acl-name – Name of the ACL. (Maximum length: 32 characters)
D S
EFAULT ETTING
None
– 1170 –
Mode
GC
IPv6-
STD-ACL
IPv6-
EXT-ACL
IC
PE
PE