Edge-Core ECS4660-28F Management Manual page 1882

| IP Routing Commands
C 51
HAPTER
Border Gateway Protocol (BGPv4)
neighbor
unsuppress-map
C U
OMMAND SAGE
This command sets the time to wait before attempting to reconnect to a
BGP neighbor after having failed to connect. During the idle time specified
by the Connect Retry timer, the remote BGP peer can actively establish a
BGP session with the local router.
E
XAMPLE
Console(config-router)#neighbor 10.1.1.66 timers connect 100
Console(config-router)#
This command allows routes suppressed by the
(summary-only option) to be advertised to specified neighbors. Use the no
form to remove this configuration entry.
S
YNTAX
[no] neighbor {ip-address | group-name} unsuppress-map
map-name
ip-address – IP address of a neighbor.
group-name – A BGP peer group containing a list of neighboring
routers configured with the
map-name – Name of the route map. The route map can be used to
filter the networks to advertise. (Range: 1-80 characters)
C M
OMMAND ODE
Router Configuration
D S
EFAULT ETTING
No exceptions
C U
OMMAND SAGE
This command is used to leak routes suppressed by the
command (with summary-only option) to specified neighbors. Other routes
that meet the route map conditions, but have not been suppressed, will
still be sent.
E
XAMPLE
Console(config-router)#neighbor 10.1.1.66 unsuppress-map rmp
Console(config-router)#
– 1882 –
aggregate-address
neighbor peer-group command.
aggregate-address