Edge-Core ECS4660-28F Management Manual page 981

Hide thumbs Also See for ECS4660-28F:

Table of Contents

Console(config)#synce

Console(config)#exit

Console#show synce

SyncE Status:

This command enables SyncE on a port that supports SyncE. Use the no

synce ethernet

form to disable SyncE on a port.

[no] synce ethernet unit/port

Global Configuration

This command only enables SyncE on the specified port. It does not

configure the port to be the clock source.

This command can enable SyncE on trunk member but not on a trunk.

SyncE can only be enabled on two ports at the same time.

Console(config)#syncd ethernet 1/28

Console(config)#

Clock Source

------------

unit - Unit identifier. (Range: 1)

port - Port number. (Range: 25-28)

| System Management Commands

Synchronous Ethernet

Chapters

Table of Contents