Edge-Core ECS4660-28F Management Manual page 1083

pppoe
intermediate-agent
port-enable
pppoe
intermediate-agent
port-format-type
E
XAMPLE
Console(config)#pppoe intermediate-agent format-type access-node-identifier
billibong
Console(config)#
This command enables the PPPoE IA on an interface. Use the no form to
disable this feature.
S
YNTAX
[no] pppoe intermediate-agent port-enable
D S
EFAULT ETTING
Disabled
C M
OMMAND ODE
Interface Configuration (Ethernet, Port Channel)
C U
OMMAND SAGE
PPPoE IA must also be enabled globally on the switch for this command to
tack effect.
E
XAMPLE
Console(config)#int ethernet 1/5
Console(config-if)#pppoe intermediate-agent port-enable
Console(config-if)#
This command sets the circuit-id or remote-id for an interface. Use the no
form to restore the default settings.
S
YNTAX
pppoe intermediate-agent port-format-type {circuit-id |
remote-id} id-string
circuit-id - String identifying the circuit identifier (or interface) on
this switch to which the user is connected. (Range: 1-10 ASCII
characters)
remote-id - String identifying the remote identifier (or interface)
on this switch to which the user is connected. (Range: 1-63 ASCII
characters)
D S
EFAULT ETTING
circuit-id: unit/port:vlan-id or 0/trunk-id:vlan-id
remote-id: port MAC address
C M
OMMAND ODE
Interface Configuration (Ethernet, Port Channel)
– 1083 –
| Authentication Commands
C 28
HAPTER
PPPoE Intermediate Agent