Edge-Core ECS4660-28F Management Manual page 1687

C
◆
◆
E
The following tells hosts to use stateful autoconfiguration to obtain other
non-address information from a DHCPv6 server:
This command configures the interval between transmitting IPv6 neighbor
ipv6 nd ns-interval
solicitation messages on an interface. Use the no form to restore the
default value.
S
D
1000 milliseconds is used for neighbor discovery operations
0 milliseconds is advertised in router advertisements
C
Interface Configuration (VLAN)
C
◆
◆
U
OMMAND SAGE
The "other-stateful-configuration" flag tells hosts that they should use
stateful autoconfiguration to obtain information other than addresses
from a DHCPv6 server.
Some hosts interpret the "other stateful configuration" flag to indicate
that they should use stateless address autoconfiguration to get IPv6
address (based on the IPv6 prefixes found in router advertisements)
and stateful autoconfiguration to get other non-address parameters
from DHCPv6 servers. In this case, the absence of both the "managed
address configuration" flag and the "other stateful configuration" flag is
interpreted to mean that they should use only stateless
autoconfiguration to obtain addresses.
XAMPLE
Console(config)#interface vlan 1
Console(config)#ipv6 nd other-config-flag
Console(config)#
YNTAX
ipv6 nd ns-interval milliseconds
no ipv6 nd ns-interval
milliseconds - The interval between transmitting IPv6 neighbor
solicitation messages. (Range: 1000-3600000)
S
EFAULT ETTING
M
OMMAND ODE
U
OMMAND SAGE
When a non-default value is configured, the specified interval is used
both for router advertisements and by the router itself.
This command specifies the interval between transmitting neighbor
solicitation messages when resolving an address, or when probing the
reachability of a neighbor. Therefore, avoid using very short intervals
for normal IPv6 operations.
– 1687 –
| IP Interface Commands
C 49
HAPTER
IPv6 Interface