Edge-Core ECS4660-28F Management Manual page 1920

| Multicast Routing Commands
C 52
HAPTER
General Multicast Routing
show ip mroute
C M
OMMAND ODE
Global Configuration
C U
OMMAND SAGE
This command is used to enable IPv4 multicast routing globally for the
◆
router. A specific multicast routing protocol also needs to be enabled on
the interfaces that will support multicast routing using the
command, and then specify the interfaces that will support multicast
routing using the ip pim dense-mode
commands.
To use multicast routing, IGMP proxy can not enabled on any interface
◆
of the device (see ip igmp proxy
E
XAMPLE
Console(config)#ip multicast-routing
Console(config)#
This command displays the IPv4 multicast routing table.
S
YNTAX
show ip mroute [group-address source] [summary]
group-address - An IPv4 multicast group address with subscribers
directly attached or downstream from this router.
source - The IPv4 subnetwork at the root of the multicast delivery
tree. This subnetwork contains a known multicast source.
summary - Displays summary information for each entry in the IP
multicast routing table.
C M
OMMAND ODE
Privileged Exec
C U
OMMAND SAGE
This command displays information for multicast routing. If no optional
parameters are selected, detailed information for each entry in the
multicast address table is displayed. If you select a multicast group and
source pair, detailed information is displayed only for the specified entry. If
the summary option is selected, an abbreviated list of information for
each entry is displayed on a single line.
– 1920 –
or ip pim sparse-mode
on page 1523).
router pim