Edge-Core ECS4660-28F Management Manual page 1957

This command configures the maximum time before transmitting a
ipv6 pim
triggered PIM Hello message after the router is rebooted or PIM is enabled
trigger-hello-delay
on an interface. Use the no form to restore the default value.
S
D
5 seconds
C
Interface Configuration (VLAN)
C
◆
◆
E
This command displays information about interfaces configured for PIM.
show ipv6 pim
interface
S
C
Normal Exec, Privileged Exec
C
This command displays the PIM settings for the specified interface as
described in the preceding pages. It also shows the address of the
designated PIM router and the number of neighboring PIM routers.
YNTAX
ipv6 pim trigger-hello-delay seconds
no ipv6 pim trigger-hello-delay
seconds - The maximum time before sending a triggered PIM Hello
message. (Range: 0-5)
S
EFAULT ETTING
M
OMMAND ODE
U
OMMAND SAGE
When a router first starts or PIM is enabled on an interface, the hello
delay is set to random value between 0 and the trigger-hello-delay. This
prevents synchronization of Hello messages on multi-access links if
multiple routers are powered on simultaneously.
Also, if a Hello message is received from a new neighbor, the receiving
router will send its own Hello message after a random delay between 0
and the trigger-hello-delay.
XAMPLE
Console(config-if)#ipv6 pim trigger-hello-delay 3
Console(config-if)#
YNTAX
show ipv6 pim [interface vlan vlan-id]
vlan-id - VLAN ID (Range: 1-4094)
M
OMMAND ODE
U
OMMAND SAGE
– 1957 –
| Multicast Routing Commands
C 52
HAPTER
PIM Multicast Routing