Table of Contents
Advertisement
neighboring router is advertising a hold-time equal to, or greater than,
that configured on this device.
E
XAMPLE
Console(config-router)#timers bgp 60 200
Console(config-router)#
This command clears connections using hard or soft re-configuration.
clear ip bgp
S
YNTAX
clear ip bgp {* | as-number | external | peer-group group-name |
neighbor-address} [in [prefix-list] | out | soft [in | out]]
* – All BGP peering sessions.
as-number – All peering sessions within this autonomous system
number. (Range: 1-4294967295)
external – All eBGP peering sessions.
peer-group group-name – A BGP peer group containing a list of
neighboring routers configured with the
command.
neighbor-address – IPv4 address of a neighbor.
in – Inbound sessions.
prefix-list – The outbound route filter (ORF) prefix list. This option
triggers a new route refresh or soft re-configuration, which updates
the ORF prefix list. This option is ignored unless ORF capabilities
have been enabled using the
command or ORF capability information has been received from a
sending peer. If ignored, a normal inbound soft reset is performed.
out – Outbound sessions.
soft – Uses soft re-configuration for the reset, which does not tear
down the session.
C
OMMAND
Privileged Exec
D
EFAULT
None
C
OMMAND
Use this command to initiate a hard reset or soft re-configuration. A
◆
hard reset clears and rebuilds specified peering sessions and routing
tables. Soft re-configuration uses stored information to reconfigure and
activate routing tables without clearing existing sessions. It uses stored
update information to allow you to apply a new BGP policy without
disrupting the network.
M
ODE
S
ETTING
U
SAGE
– 1851 –
| IP Routing Commands
C
51
HAPTER
Border Gateway Protocol (BGPv4)
neighbor peer-group
neighbor capability orf prefix-list
Advertisement
Chapters
Table of Contents
